Plate Material Evaluating Cell
This quite handy cell is developed in order to evaluate plate material such as metal, semi-conducting plate, etc. In evaluation, a sample plate is sandwiched between cell blocks.
Applicable plate dimensions:
- width: from 10 to 23 mm
- length: approximately 25 mm (depends of the connection way)
- thickness: until 3 mm
Liquid contact area:
- approximately 7.8 mm
- (It is the inner diameter of the O-ring (ID: 7.8 mm). Due to the deformation when squeezed between the blocks, the area will vary slightly.)
Description
ALS 011951 | Plate Material Evaluating Cell |
Contents
Teflon Cell [Body] | 1 | |
ALS 012864 | Plate Material Evaluating Cell Base | 1 |
Teflon cap | 1 | |
O-ring | 1 | |
Screw 20 mm | 2 | |
ALS 010537 | Purge tube (ETFE) (1m) | 1 |
ALS 002222 | Platinum counter electrode 5.7 cm | 1 |
∗ Additional o-ring:
- ALS 012022 O-ring for Plate Material Evaluating Cell, 10 pcs, Viton
- ALS 012023 O-ring for Plate Material Evaluating Cell, 10 pcs, silicone
Cell Set Up
The assemble will be shown below, where each step will be explained with the photo switches.
- Prepare the required parts.
- Set the plate on the bottom Teflon block.
- Set the Teflon block which contains the o-ring over the plate, and tight the screw left/right uniformly (the surface of the plate in contact with the solution will depends of the inner diameter of the o-ring)
- Confirm whether the plate is fixed adequate, and fill with the electrolytic solution (approximately 1 mL).
- Set the counter electrode and a reference electrode on the battery cover, then fix it to the cell. The Pt counter electrode, from the kit is a little long, please wind before use.
- Do the connection using the alligator clip.
